Pneumatic And Hydraulic Equipment Page 439

AIRPICKER AirPicker end-effector consists of a fabric reinforced rubber bladder swaged onto a metal body with two stainless steel clamp rings. The body of the picker tuns the length of the part and is machined stainless steel, plated steel, or aluminum, depending upon its size. An air passage is drilled through the center of the body and tees off into the inflatable bladder area. Mounting holes or threads are also machined into the body. The type of mounting depends upon the size of the end-effector. A threaded hole is also machined into the body for mounting a nose cone. Due to the small size of AirPicker end-effectors, the corrosion resistance and strength of stainless steel are available without adding a significant amount of weight. The P006-P009 sizes have a single air passage at the top with a threaded body for mounting. Steel (Plated) P010 - P025 Plated steel is an inexpensive and durable material for the mid-range size picker end-effectors. The P010 - P025 have two tapped holes, one for the air fitting, the other as a mounting attachment. The hole that is not used for the air passage must be plugged to prevent air loss. Aluminum P035 - P055 Strong, lightweight aluminum is used for the larger AirPicker end-effector (P035 - P055). The P035 has indentical mounting and air passage design as the smaller P010-P025. The P045 and P055 also have two tapped holes, along with three equally spaced mounting holes on top to handle their greater load capacities. Stainless Steel P006 - P009 Body F I R E S T O N E Firestone JHF Catalog [ Volume 7 ] (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com 439 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page