Pneumatic And Hydraulic Equipment Page 192

FOP The model number for all Multiple Position FOP Flat-1 cylinders consists of three alphanumeric clusters. The first cluster designates type, the second cluster bore size and stroke lengths A and B, and the third cluster designates mounting and special options. Please refer to the charts below for an example of Model Number FOP 170.375/0.25-1V. This is a 1-1/2" bore multiple position FOP Flat-1 with a 3/8" stroke for position A, plus an additional stroke of 1/4" for position B, with a pivot mount on the rear head and high temperature seals. How to Order FOP-170.375/0.25-1V TYPE BORE SIZE STROKE LENGTH A FOP - Double acting multiple position, single end rod STROKE LENGTH B 02 - 9/16" 31 - 2" 04 - 3/4" 50 - 2-1/2" 09 - 1-1/16" 70 - 3" 17 - 1-1/2" 125 - 4" 0.25 - 1/4" 0.375 - 3/8" 0.625 - 5/8" ETC. 0.25 - 1/4" 0.375 - 3/8" 0.625 - 5/8" ETC. MOUNTING OPTIONS OPTIONS (Enter in alphabetical order, except EE which is last) (Enter in numeric order) CFT - Coarse female rod thread (fine thread standard) CMT - Male rod thread end (coarse thread) G - Magnalube G L - Low friction seals M, M1, M3, M4 - Magnetic position sensing 1 MT - Male rod thread end (fine thread) NT - Non-threaded rod P2*, P3, P4* - Front port position #2, etc. P6*, P7, P8* - Rear port position #6, etc. Q - Low temperature option (-40 F to 200 F) T1, T3, T4 - Additional switch mounting post located in position #1, #3 or #4 V - High temperature option (0F to +400 F) 1 W - Rod wiper (Buna-N only) Y - Moly-coat (MoS 2 I. D. coating) EE0.375 - 3/8" extra rod extension EE1 - 1" extra rod extension, etc. *Not available in 9/16" bore 1 If magnetic position sensing is specified with option V, standard Buna-N based magnet will be provided. Magnetic position sensing is not reliable above 200 F. No Number - Basic model (Standard counterbored mounting holes) 1 - Pivot mount 1N - Pivot mount 90 from standard 3 - Threaded mounting holes, both ends 3F - Threaded mounting holes, front 3R - Threaded mounting holes, rear 4 - Screw clearance holes, both ends 1 4F - Screw clearance holes, front 1 4R - Screw clearance holes, rear 1 "Screw clearance" to allow bolt head to pass through; no counter bores. Bimba (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com JHF Catalog [ Volume 7 ] 192 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page