Pneumatic And Hydraulic Equipment Page 171

B I M B A SQUARE FLAT-1 SERIES How to Order The convenient alternative for horizontal and side mounting, with provisions for both a bottom flush or face mounting. The Square Flat-1 also minimizes the centerline distance when cylinders are mounted side-by-side. Body - 304 Stainless Steel Heads - Anodized Aluminum Alloy Piston Rod - Ground and Polished 303 Stainless Steel Seals - Buna N (High temperature seals optional) Rod Bushing - Oil Impregnated Bronze Tie Rods - 303 Stainless Steel Spring Forces - See Spring Force Chart Pressure Rating - Bore Sizes 3/4"-2" 200 PSI Maximum (Air only) Bore Sizes 2-1/2"-4" 150 PSI Maximum (Air only) Temperature Rating - From -20F to +150F Buna N seals with a temperature range of -20F to +150F are standard in all Bimba air cylinders. Fluoroelastomer seals rated for higher temperature applications are available. If cylinders are operated below 0 for extended time periods, special modifi cations may be required. Special seal materials are available upon request. The Model Number for all Square Flat-1 cylinders consists of three alphanumeric clusters. These designate type, bore size and stroke length, and options. Please refer to the charts below for an example of Model Number FS-170.375-1V. This is a double acting, 1-1/2" bore, 3/8" stroke, pivot mount cylinder with high temperature option. FS-170.375-1V Type FS - Double Acting, Single End Rod FSD - Double Acting, Double End Rod FSR - Reverse Acting FSS - Single Acting STROKE LENGTH 0.125 - 1/8" 0.25 - 1/4" 0.375 - 3/8" ETC. MOUNTING OPTIONS OPTIONS (Enter in alphabetical order, except EE which is last) B - Bumpers, both ends 1 BF - Bumpers, front only 1 BR - Bumpers, rear only 1 CFT - Coarse female thread CMT - Male rod end (coarse thread) G - Magnalube G H - Hollow rod (double end models only) J - Failsafe operation (FSS models) L - Low friction seals M, M1, M4 - Magnetic position sensing 2 MT - Male rod end (fine thread) NT - Non-threaded rod Q - Low Temperature option (-40 0 F to 200 0 F) T1, T4 - Additional switch track located in position #1 or 4 V - High temperature option (0F to 400 F) W - Rod wiper (Buna N) Y - Moly-coat (MoS 2 I. D. coating) EE0.375 - 3/8" extra rod extension, etc. EE1 - 1" extra rod extension, etc. 1 Stroke is reduced by .03" per end. (.06" for option B). FSS, BR only; FSR, BF only. 2 If magnetic position sensing is specified with option V, standard Buna-N based magnet will be provided. Magnetic position sensing is not reliable above 200 F. No Number - Basic model 1 - Pivot mount 1N - Pivot mount 90 from standard BORE SIZE 04 - 3/4" 09 - 1-1/16" 17 - 1-1/2" 31 - 2" 50 - 2-1/2" 70 - 3" 125 - 4" Bimba JHF Catalog [ Volume 7 ] (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com 171 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page