Pneumatic And Hydraulic Equipment Page 141

B I M B A ORIGINAL LINE-500 HYDRAULIC CYLINDERS Hydraulic Cylinders HEX-STUD made from heat treated alloy steel. In case of failure due to overload, the hexagon portion will remain in rod and can be easily removed Sintered bronze piston rod guide bushing "O" ring TIE-BANDS reinforce both ends of type 304 stainless steel body rolled in a groove on the periphery of each end cap doubling joint strength "O" ring Sintered bronze pivot bushing Leather Back-up rings Buna N rod wiper seal assures dry drip free piston rod Block V seal with back up washer Piston rod - hard chrome plated Filled PTFE bearing Buna N block V seals with back up washers Piston rod piloted into piston - threaded and riveted High strength aluminum alloy endcaps & piston MAGNET (prefix M) Example: HM-096-DZ 4" stroke or greater required Overall length increases by 0.25" 1-1/16" Bore add $14.00 1-1/2" Bore add $16.80 2" Bore add $19.65 FLUOROELASTOMER SEALS (V) Specify for compatibility 1-1/16" Bore add $26.70 1-1/2" Bore add $33.30 2" Bore add $40.05 OPTIONS continued... Enter Stroke Length as 3rd Digit The Bimba "500" is a precision built, compact, lightweight hydraulic cylinder designed specifically for hydraulic use only, at pressures up to 500 psi. Rated 500 PSI Hydraulic (non-shock), Double Acting EXTRA EXTENSION (EE), PER INCH OF EXTENSION: 1-1/16" Bore add $1.30 per inch 1-1/2" Bore add $1.85 per inch 2" Bore add $2.05 per inch PORTS ROTATED 90 DEGREES (K) (no charge) OPTIONS: Bimba JHF Catalog [ Volume 7 ] (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com 141 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page