Pneumatic And Hydraulic Equipment Page 1170

Typical Application Pneumatic instrumentation circuits, lubricant and cooling lines. Pressure Working pressure up to 500 psi with a 4:1 safety factor depending on tube size. Vibration Excellent resistance. Temperature Range Depends on tubing used. -65F to +250F with brass sleeve, -40F to +150F with plastic sleeve. (Refer to tubing temperature range.) Material CA360 Brass body, plastic sleeve. Used With Aluminum, copper and hard plastic tub- ing requires brass sleeve. Weatherhead PT200 and PT240 plastic tubing use plastic sleeve. Not recommended for steel tubing. Advantages No flaring of tubing required. Easy instal- lation, captive sleeve, preassembled for installation and can be reassembled. Note 1/8" and 3/16" tube O.D. assemblies are supplied with brass sleeves and no inserts. Assembly Instructions 1. Cut tubing to desired length. 2. Slide nut/sleeve assembly on tube. Threaded end "A" of nut must face toward fitting. 3. Bottom tubing into fitting. 4. Plastic sleeve - tighten nut, hand tight. Brass sleeve - tighten nut, hand tight, then additional 3/4 turn. Label Set: FS-2100 (adhesive) CL-498 (non-adhesive) TUBE PART O.D. NUMBER PRICE 1/4 1260X4 $0.14 5/16 1260X5 $0.23 3/8 1260X6 $0.14 1/2 1260X8 $0.52 PLASTIC SLEEVE Size X2 X3 X46 X4 X5 X6 X8 Tube O.D. 1/8 3/16 1/4 5/16 3/8 1/2 Thread Size-B 5/16-24 3/8-24 7/16-24 1/2-24 11/16-20 Flow Dia. (D1) .094* .125* .078 .125 .141 .203 .312 Support Dia. (D2) - .120 .166 .180 .245 .370 *No tube support in assembly-Flow Diameter for body only. POLYLINE FLARELESS BRASS FITTINGS Weatherhead Eaton Weatherhead hose and fittings (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com JHF Catalog [ Volume 7 ] 1170 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page