Pneumatic And Hydraulic Equipment Page 1035

HH SERIES-TIE ROD AND DOUBLE ROD MOUNTINGS K ZT + STROKE ZB + STROKE P + STROKE EE LB + STROKE VB RD-.001 -.003 BB J BB DD FA WF R E R AA B. C. DIA. E MM ROD DIA. K G K FF Y W STROKE MM DIA. EE P + STROKE ZL + STROKE ZM + (2 x STROKE) LD + STROKE E RD E G K G Y WF STROKE MM ROD DIA. EE P + STROKE ZL + STROKE ZM + (2 x STROKE) LD + STROKE K TIE RODS EXTENDED NX - Neither (MXO)* BX - Both (MX1)* RX - Rear (MX2)* FX - Front (MX3)* *ANSI/B93.1-1964 Mounting Style Designation. Available in all except C mounts. BASIC DOUBLE ROD CYLINDERS BB FF WF DD K Reference adjacent drawing. RX MOUNT - The round gland retainer shown above is not used on the 1-1/8" bore, 1-1/2" bore, or the 2-1/2" bore with a 1-3/4" rod diameter or the 3-1/4" bore with a 2" rod diameter. A square retainer, the same square size as the head, is employed in these sizes. The retainer is held in place with retainer screws and the gland can be removed without loosening the tie rods. FX and BX MOUNTS - The square retainer is used on the 1-1/8" bore, 1-1/2" bore, 2" bore, the 2-1/2" bore with a 1-3/8" and 1-3/4" rod diameter, and the 3-1/4" bore with a 2" rod diameter. The retainer is held in place by the tie rod nuts, hence, the gland cannot be removed without loosening the tie rods. NX MOUNT - The square retainer is used on the 1-1/8" bore, 1-1/2" bore, and the 2" bore with a 1-3/4" diameter rod and the 3-1/4" bore with a 2" rod diameter. The retainer is held in place with retainer screws that thread into the head and the rod gland can be removed without loosening the tie rods. IMPORTANT NOTICE There is a construction variance in the 1-1/8" bore, 1-1/2" bore, 2" bore, the 2-1/2" bore with a 1-3/8" and 1-3/4" rod diameter, and the 3-1/4" bore with a 2" rod diameter. The round gland retainers shown above are not used in these sizes. A square retainer, the same square size as the head, is employed on each end. The retainers are held in place by the tie rod nuts and therefore cannot be removed without loosening the tie rods. See adjacent drawing for dimension details. For dimensions on specific mounting styles, consult other pages in this bulletin and separate Accessories Section. Dimensions shown on the above and adjacent drawings are for the BASIC CYLINDER ONLY. Double rod extension cylinders are available in every mounting style except clevis. IMPORTANT NOTICE S H E F E R Sheffer cylinders JHF Catalog [ Volume 7 ] (314) 427-0600 800-444-0522 (FAX) 314-427-3502 www. j hf.com 1035 Prices Subject to Change Without Notice John Henry Foster pneumatic and hydraulic equipment

Previous Page
Next Page